Gold Prospecting Forum
http://goldprospectingforum.com/

Reducing a Water Pump
http://goldprospectingforum.com/viewtopic.php?f=28&t=2472
Page 1 of 1

Author:  goldhog [ Tue Jan 13, 2015 7:49 pm ]
Post subject:  Reducing a Water Pump

Shown below is what I use to reduce 2" semi-trash pumps to 1.5" hoses.
We also use the same setup to reduce 3" pumps to 2"
Reducing at the pump saves money on hose and bulk.
Also.... before you glue it up, MAKE SURE the handle clears the "roll cage" around the pump.
Otherwise you won't be able to screw it on. Yes, guilty as charged.
ALSO.... reducing the pump OUTFLOW will NOT damage the pump.

If someone has told you this... send them this article.
It's not that they're stupid... they are just passing down a MYTH.
http://www.cyclestopvalves.com/csvtechinfo_21.html
It is actually GOOD for a pump.

Attachment:
reduce.jpg
reduce.jpg [ 434.03 KiB | Viewed 3332 times ]

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/